Does The Unit Proceed Straight?; How To Adjust And Check - Hirobo S.R.B. Quark User Manual

@
Does the unit proceed straight?
ll the he i f ies s deways when foMard input s made, or if the
hei flies foMards or backwards when aileron or elevator is
lnput when hover n9, please check the orientation of the main
shalt componenls as piclured below
lf the washout cenier hub and mixing arms are nol perp ndicular
to lhe siabiizer blade as show in the diagram, oosen screws C
and/or D, realtach screws C and/or D and check orrentalion ol
these paris again. Adjust unil ihe two assemblies are
perpindicu ar to each other.
li the screws are overtightened n the holes on the main shaft, the
orienlation angles may become misa igfed. Do not overtighten.
Stabr zer blade
Cenler hub
How to adiust and check
1. A ign lhe A and B balls on the same axis.
2. l\,4ake sure that lhe stab zer ll ade is
perpendicular to the wash control arn
and the swash plaie.
3. li they are not perpendic!lar, loosen
screws C and D to adjust ihe angle and
then re{lghten them.
ea.z.--2?..-,4r E r4
_15