Disassembling And Reassembling; General Guidelines; Rotor Head; S.r.b. Control Unit - Hirobo S.R.B. Quark User Manual

12di,"oJp.e."*,gmp,"linp*nn9;ge-".""-g"nlkli
12-1 . General guidelines on disassembling the flying unit
Rotor head
Remove the swash base Plale
rod end attached to lhe swash
plaie ball, and loosen the main
I,42X6CS to remove the enlire
mast.
ano
gear
main
S.R.Bswash base plate
Frame motor
s.R.B. Control unit
Loosen the lhree [/1.7X8TS
screws, and slide upwards so the
control lnit can be removed llom
Disconnect the tail motor connector
and loosen the eight M1.4X5TS
screws io remove the iail irom the
matn lrame.
M2X6CS (oily needsto be loosened)
the main irame.
skid
Loosen lhe four M1.4X5TS screws lo
remove the skid from the main irame.
@a
M 1 . 7 X 8 T S
IV] 4X5TS
ls the main geal screw tight?
lf the M2x6 cap screw in the lower mast lock attached to the
lower black main geal comes loose, the main gear will slip
on the main shaft and the motor will nol be able io drive the
rnain roior head properly thus not allowing the helito lil't off
when power is applied. Please check this screw from time
to time as part ol maintenance.
Cap screw M2X6
Allen wrench 1.5 mm (accessones)
To rtuv.nl bFaking orovenighteni|-s ol the s.rc$. place the tip ofthe knrg'r end ol
$c alerrvenchinrotheh€ad oflhecrp \ctuw Llse ihe shoncr end as thcrglrtenrnC
lerer IIlh.lon8ersidc is lsei 4 thc tiAhtering l.vcr and ihe \hodor end N Put rnto
rhccapscre$.you mat br€al drc scEN duc10ovediehtt ng
32