Table of Contents
Advertisement
6. Throttle adiustment
When using a commercially available transmiiier, since the ihrottle rudder
angle difiers depending on iransmitters, it musl be adjusted by following ihe
Procedures outlined below.
IP.ocedures]
O Turn the transmiiter power on.
@ Place the unit on a flat surface, and turn on the power switch- Do not move
the unit untillhe flashing green LED lurns lo a solid green.
@ Set the transmitter throttle stick to the slowest seiting.
Adjust the lhrotlle stick by turning ihe THR ATT (lhrotUe) adjustmeni
volume untilthe red LED lights up.
(Pointl
You cannot
safety device
green ancl red
the same time.
disengage the
until both the
LEDS light up ai
Tl-lR ATT Thrott e adjlslment volume
The lhroi e's slowesl posltio. s raised
@ Raise the throtlle stick, and check that me red
siick posiiion at which the red LED iurns off is
molor slans.
@ Wiih the transmitter throttle stick in the slowest
LED on the conlrol unii on, pressing the start
safety device and allow the rnotor io stair
LED has turned otf. The
the position at which the
position and with the red
switch wiil disengage the
7. Budder neutral adjustment
Please refer to secton 09-5 on page 26 for instruclions on adjusling ihe
rudder irim.
30
Hide quick links:
Advertisement
Table of Contents
