Procedure For On/Off Power Witches - Hirobo S.R.B. Quark User Manual

07-3. Procedure for ON/OFF Power witches
O A safety device is incorporated in the helicopter to
prevent runaway due to incorrect operation.
The helicopter s designed to ensure lhal the motor will not turn unless the
switch is turned ON wiih lhe correct procedure.
Turn lhe switch ON with the following procedure.
The following explains the transmitter supplied with ihe fullsei.
lf you have purchased the set without the programmable transmitter, a
transmitter mlst be obtained separately. See page 28 '10 Using a
Commercial Transmitter' for details.
o
1 .
2.
Turn the switch ON tollowing the procedure 1. - 5 below.
Set the llying unit on a flat surface.
Extend the antenna of the transmitler,
and lurn the power switch ON.
3. Press the power switch on the
flashing green LED lamp turns to
unit. (Do not move the
a constant green.)
unit until the
stick to the lhrottle
model I
the very botto
lMode-l
E
/ f E
The S.R.B is now ready for flight.
Side of the llvinq unii
r6i
Lit red
,f9.
rit steen
LED amp
Bolh the green and red LEDS are t when lhe throttle stick is moved lo the very bottom.
' The molor wi I nol turn when lhe Starl sw tch is pressed L n ess lhe green and red LEDS are it
5. Press the Start swilch.
__.rr =
n-, /(-a=
AGaution
O When turning the power
switches ON, first iurn the
trarsmitter
switch ON,
followed by the power
swiich on the flying unit.
When turning the power
switches OFF, first tum the
power switch on the flying
unit OFF, Iollowed by the
power
swilch on the
transmitter.
aDo not move the unit until
the llashing green LED lamp
tulns to a constant green.
While the green LED lamp is
flashing, the gyro tries to
find the neutral posiiion. lf
you move the unit during
this period, the gyro will be
unable lo accurately lind this
position, causing an error.
' lf the red and green LED
lamps alternately flash on
and off, it indicates that an
error has occurred. lI an
etror occurs, please turn
the unit off and then switch
the power back on again.
lPointl
C)lf the unit is not operaled
wilhin five minutes of
turning the power on, it will
automatically turn off .
(Turning the power offl
OBefore turning the power off,
please
alisconnect the
batlery connector.
lf the power switch is held
alown for longer than one
second, a series of tones
will sound and the power
willturn off.
l 3