Using The Control Unit - Hirobo S.R.B. Quark User Manual

a Names and functions of the S.R.B. control unit parts
The volume and switches of the S.R.B. conirol !nil are adjusied al the factory before it is shipped,
so please do not atrempi to adjust the settings before flying the unil for the first time.
RUD NT FLdder neutra adiushentvolume
RUD ATT Rudder rate adluslmenl volume
THB ATT Thronle adjustmen t volume
THR CRV Thrcnle curye adtuslmenlvoume
V e w n 9 f r o m t h e t o r t , w i n d l h e
anlenna wire ioLr times clockwise.
AIL Connecls the aileron seruos
ELE Connecls the eievaror seruos
wind the anlenna wire iourtimes
Crysla
Do nol rehove the crystal except lo
The egs oi lhe crystalare
deicate so please be carelu
hotlo bend or break theh
when re jnseidnq lhe crysta.
Transmlner selecrion switch
See Page 28lordetails on howlo sel.
1
2
3
4
Please set this lo OFFwhen tn usb.
Alleror/elevator
anqle switch
'See Page 40 for
detais.
ACaution
No not attempt to dismantle or modify the control unit. This may cause a malfunction.
Use only Hirobo-designated batteries.
Use only genuine Hirobo crystals.
Do not wrap the entire antenna wite around lhe antenna holder, and leave the excess wire free.
Never cut the antenna wirc. cutting the antenna wire willshorten lhe distancewhich the radio wave can reach.
s{i #h
rerlbrg
9