Yamaha RX10LTGTYL Service Manual page 673

DRIVE CHAIN HOUSING
INSTALLATION
1. During installation, pay attention to the fol-
lowing.
A Properly install the rubber seal onto the drive
chain housing, making sure that there are no
gaps.
B Make sure that the bearing seals face towards
the drive chain as shown.
C C Be sure to install the spacers in their origi-
1 2
nal positions, otherwise the brake disc and
jackshaft will stick.
D 0.2 X 0.7 mm (0.008 X 0.028 in)
: ESSO beacon 325 grease or Aeroshell
grease #7A
For the jackshaft and drive chain housing instal-
lation, refer to "SECONDARYSHAFT".
2. Install:
S Lever rod 1
3. Adjust:
S Lever rod length a
Adjustment steps:
S Loosen the locknuts 2 .
S Turn the lever rod 1 in or out until the speci-
fied length is obtained.
Lever rod length:
27 mm (1.06 in)
S Tighten the locknuts.
25
POWR
TR