Further Settings - Otto Bock Kimba neo Instructions For Use Manual

Adjustments

6.2.4 Further settings

The following fitting tasks are described in more detail in the included Instructions for Use (User) – reference num­
ber 647G770:
• Adjusting the back angle
• Adjusting the seat angle (seat tilt)
6.3 Headrest supports (multifunctional seating unit)
6.3.1 Adjusting the headrest support
1) Open the zipper of the padding cap (see Fig. 3) and push the padding behind the seat to the side.
2) Loosen the knurled nuts on the back of the back plate.
3) Adjust the width by moving the supports in the slotted holes (see Fig. 48, Pos. 1).
4) Adjust the height by shifting the supports in the holes of the back plate (see Fig. 48, Pos. 2).
INFORMATION: A further height adjustment of the headrest supports is possible by adjusting the
back height.
5) Hand-tighten the knurled nuts.
6) Close the padding again.
6.3.2 Fitting the integrated headrests
1) Open the zipper of the padding cap (see Fig. 3) and remove the padding from the integrated headrests.
2) To fit the free space in the head region, glue up to 3 foam pads, each 1 cm thick, on the headrests (see
Fig. 49, Pos. 1/see Fig. 50, Pos. 1).
3) Put back/close the padding again.
24 | Ottobock
47
49
48
50
Kimba neo