Integrated Headrests; Safety Belts; Strap Guide - Otto Bock Kimba neo Instructions For Use Manual

Preparation for Use
3) Put the mounting screws through the slotted hole in the headrest support and through the hole in the back
plate (see Fig. 6).
INFORMATION: If the headrest supports are to be mounted to the top holes (= mounting points of the
back plate), the longer mounting screws, which come with the device, will have to be used instead of
the regular mounting screws.
4) Fasten the headrest supports on the back of the back plate using the knurled nuts.
5) If necessary, adjust the width. Hand-tighten the knurled nuts.
6) Close the padding again.

5.2.1.2 Integrated headrests

Assembly is done at the factory following receipt of an order.
To change the distance of the headrests:see Page 24.

5.2.2 Safety belts

5.2.2.1 Strap guide

For improved belt guidance in the pelvic area, strap guides must be installed in the following cases:
• Lap belt; lap-belt part of the four/five-point belt: installation position see Fig. 7, Pos. 1
• Bottom mounting strap of the chest and shoulder support: installation position see Fig. 7, Pos. 2
1) Put on the strap guide from the inside, connecting the flat side to the fastening point of the seating unit (see
Fig. 8, Pos. 1).
2) Put the mounting screw through the fastening point from the outside (see Fig. 8, Pos. 2) and screw it into the
strap guide.
3) Pre-mount the strap guide with the washer/cap nut.
4) Twist the strap guide in the direction of use and finish assembly (see Fig. 7).
10 | Ottobock
5
7
6
8
Kimba neo