Adjusting The Pelvic Band - Otto Bock Kimba neo Instructions For Use Manual

Adjustments
• Moving the belts in the 2 clips on the back plate (see Fig. 35, Pos. 2/3)
• Moving the belts in the strap adjustment at the leg straps (see Fig. 33, Pos. 5/6)

6.4.6 Adjusting the pelvic band

INFORMATION
The application of the product is described in the Instructions for Use (User).
The pelvic band can be adjusted as follows:
• Moving the supports on the crossbar (see included Instructions for Use 647G129)
• Sliding the band onto the plastic mounting rail (see included Instructions for Use 647G129)
6.4.7 Adjusting the hook & loop foot straps
INFORMATION
The application of the product is described in the Instructions for Use (User).
The hook-and-loop foot strap can be adjusted as follows:
• Moving the hook-and-loop foot straps against each other (no illustration)
6.5 Footplate
6.5.1 Adjusting the footplate height (lower leg length)
1) Loosen the Allen head screws (see Fig. 52, Pos. 1).
2) Adjust the footplate height (lower leg length).
3) Tighten the Allen head screws again.
6.5.2 Adjusting the footplate angle (option)
1) Loosen the fastening nuts of the locking screws in the slotted holes (see Fig. 53, Pos. 1).
2) Move the locking screws. Pay attention to the setting, so that a parallel adjustment is assured.
3) Align the wide slots of the locking screws perpendicular to the slotted holes in the footrest, so as to ensure
wear-free locking.
4) Tighten the fastening nuts of the locking screws again.
6.5.3 Further settings
The following fitting tasks are described in more detail in the included Instructions for Use (User) – reference num­
ber 647G770:
• Adjusting the knee angle
26 | Ottobock
52 53
Kimba neo