Four-Point Belt - Otto Bock Kimba neo Instructions For Use Manual

5.2.2.3 Four-point belt

1 Clip with rivet
2 Shoulder belt, left/right
3 Belt pads
4 Strap guide with attachment fitting
Installing the four-point belt
1) Mount the strap guide (4) according to the chapter "Strap guide" (see Page 10, see Fig. 15, Pos. 1).
2) Rivet 2 clips (1) to the holes of the bottom back plate (see Fig. 15, Pos. 2).
3) Run the shoulder belts (2) through the padding/back plate (see Fig. 16) and secure them in the clips (see
Fig. 15, Pos. 3).
4) If necessary, cut off protruding belt ends of the shoulder belts and melt the free ends by applying heat (such as
from a lighter).
5) Mount the lap-belt part (5) according to the chapter "Lap belt" (see Page 11).
→ The four-point belt is installed properly if the latches can be clipped into the buckle (8).
Kimba neo
5 Lap-belt part
6 Belt restraint
7 Adjustment buckle
8 Belt buckle with release button
Preparation for Use
14
Ottobock | 13