Chest And Shoulder Support - Otto Bock Kimba neo Instructions For Use Manual

5.2.3.3 Chest and shoulder support

1 Pair of clips with attachment fitting
2 Shoulder belt
3 Bottom attachment strap
Mounting the chest and shoulder support
1) Mount the strap guide according to the chapter "Strap guide" (see Page 10).
2) Mount the pairs of clips (1) using mounting screws/knurled nuts in the slotted holes of the bottom back plate
(see Fig. 28, Pos. 1/see Fig. 29, Pos. 1).
3) Place the chest and shoulder support on the seat bottom – the sewn-on clips (5) must point towards the seat
bottom.
4) Run the shoulder belt (2) through the padding/back plate (see Fig. 16) and secure them in the top clips (see
Fig. 29, Pos. 2).
5) Run the bottom attachment straps (4) between the seat bottom and backrest to the back through the strap
guide and secure them in the bottom clips (see Fig. 29, Pos. 3).
INFORMATION: The bottom padded ends of the chest and shoulder support are to rest subsequently
on the user's spinae.
6) If necessary, cut off protruding belt ends of the attachment straps and melt the free ends by applying heat
(such as from a lighter).
Kimba neo
4 Belt end of bottom attachment strap
5 Sewn-on clip
6 Pad
Preparation for Use
27
Ottobock | 17