Table of Contents
Advertisement
Available commands are listed below.
N
Set the domain name.
Press "N." The command prompt changes to "Enter RRP Domain Name>." Enter a
name of the domain to be configured in 25 characters or less.
T
Set the node role.
Press "N." The command prompt changes to "Enter RRP Node Type (M/T) >." Press
"M" to set the domain for a master node. Press "T" to set the domain for a transit
node.
P
Set the primary port.
Press "P." The command prompt changes to "Enter RRP Primary Port >." Enter the
port number (1-10) you wish to set as a primary port.
S
Set the secondary port.
Press "S." The command prompt changes to "Enter RRP Secondary Port >." Enter the
port number (1-10) you wish to set as a secondary port.
O
Set the polling interval.
Press "O." The command prompt changes to "Enter RRP Polling Interval>." Enter a
value between 1 and 2 (seconds) as the polling interval.
F
Set the timeout for polling.
Press "F." The command prompt changes to "Enter RRP Fail Period>." Enter a value
between 2 and 5 (seconds) as the timeout for polling.
S
Set the control VLAN ID.
Press "S." The command prompt changes to "Enter Control VLAN ID >." Enter the
VLAN ID (2-4094) you wish to set as a control VLAN. When entering two or more
port numbers, separate them with a comma without a space, or use a hyphen for
consecutive numbers.
D
Set the data VLAN ID.
Press "D." The command prompt changes to "Enter Data VLAN ID >." Enter the VLAN
ID (1-4094) you wish to set as a data VLAN. When entering two or more VLAN IDs,
separate them with a comma without a space, or use a hyphen for consecutive
numbers.
A
Set a domain.
Press "A" to apply your settings.
Q
Return to the previous menu.
Note: If you press "Q" (Quit) after setting a domain, your settings will not be
applied.
Be sure to press "A" (Apply) to apply your domain settings.
195
Advertisement
Table of Contents
