Panasonic M24PWR Operation Manual page 43

Available commands are listed below.
N Show the next page.
Press "N." The screen displays the next port.
P Show the previous page.
Pressing "P" displays the previous port.
A Enable/disable a port.
Press "A." The command prompt changes to "Select port number to be changed>."
Enter a port number you wish to configure. To configure all ports at once, enter
"0" as the port number. Then, the command prompt changes to "Enable or
Disable port # (E/D)>." Press "E" to enable the port. Press "D" to disable it. As the
change is applied, the display on the upper screen is updated automatically.
M Configure the speed and full-duplex/half-duplex settings for each port.
Press "M." The command prompt changes to "Enter port number>." Enter a port
number you wish to configure. To configure all ports at once, enter "0" as the port
number. Then, the command prompt changes to "Enter mode for port # (A/N)>."
Press "A" to enable the auto negotiation mode. Press "N" to disable it. If "N" is
selected, the command prompt changes to "Enter speed for port #(10/100)>."
Select a desired communication speed. Upon setting, the command prompt
changes to "Enter duplex for port #(F/H)>." Select "F" for full-duplex, or "H" for
half-duplex. As the change is applied, the display on the upper screen is updated
automatically.
Mode: A:
N:
Speed: 10:
100:
Duplex: F:
H:
F Enable/disable the flow control.
Press "F." The command prompt changes to "Select port number to be changed>."
Enter a port number you wish to configure. To configure all ports at once, enter
"0" as the port number. Then, the command prompt changes to "Enable or
Disable flow control for port # (E/D)>." Press "E" to enable the function. Press "D"
to disable it. As the change is applied, the display on the upper screen is updated
automatically.
S Enable/disable the AUTO-MDI function.
Press "S." The command prompt changes to "Enter port number>." Enter a port
number (from 1 to 24) you wish to configure. To configure all ports at once, enter
"0" as the port number. Then, the command prompt changes to "Enable or
Disable Auto-MDl for port # (E/D)>." Press "E" to enable the function. Press "D" to
disable it. As the change is applied, the display on the upper screen is updated
automatically.
Q Return to the previous menu.
Note: The screen displays the port status; however, the status is not
automatically updated. To display the latest status, press any key.
Enable the auto negotiation mode.
Disable the auto negotiation mode (fixing the speed at Giga is
not supported).
Set at 10 Mbps.
Set at 100 Mbps.
Set at full-duplex.
Set at half-duplex.
43