Panasonic M24PWR Operation Manual page 46

Available commands are listed below.
N Show the next page.
Press "N." The screen displays the next port.
P Show the previous page.
Pressing "P" displays previous port.
A A name can be assigned to each port.
Press "A." The command prompt changes to "Select port number to be changed>."
Enter a port number you wish to configure. To configure all ports at once, enter
"0" as the port number. Then, the command prompt changes to "Enter port name
string>." Enter a name you wish to assign. As the change is applied, the display on
the upper screen is updated automatically.
J Enable/disable the jumbo frame forwarding function.
Press "J." The command prompt changes to "Select port number to be changed>."
Enter a port number you wish to configure. To configure all ports at once, enter
"0" as the port number. Then, the command prompt changes to "Enable or
Disable jumbo status for port # (E/D)>." Press "E" to enable the function. Press "D"
to disable it. As the change is applied, the display on the upper screen is updated
automatically.
E Enable/disable the EAP packet forwarding function.
Press "E." The command prompt changes to "Enter port number>." Enter a port
number you wish to configure. To configure all ports at once, enter "0" as the port
number. Then, the command prompt changes to "Enable or Disable EAP forward
for port # (E/D)>." Press "E" to enable the function. Press "D" to disable it. As the
change is applied, the display on the upper screen is updated automatically.
Q Return to the previous menu.
Note: The screen displays the port status; however, the status is not
automatically updated. To display the latest status, press any key.
46