Panasonic M24PWR Operation Manual page 78

Available commands are listed below.
N Display the next page.
Press "N" to display the next page.
P Display the previous page.
Press "P" to display the previous page.
C Create new VLAN.
Pressing "C" opens the "VLAN Create Menu" screen. For details, refer to the section
(4.7.1.c).
D Delete a VLAN that has been configured.
Press "D." The command prompt changes to "Enter VLAN ID>." Enter VLAN ID you
wish to delete with a value of 2 to 4094.
M Set the management VLAN.
Press "R." The command prompt changes to "Enter index number>." Enter VLAN ID
you wish to configure as a management VLAN with a value of 1 to 4094.
I Configure Internet Mansion mode.
Press "I." The command prompt changes to "Enable or Disable Internet Mansion
Function? (E/D>." Enter "E" to enable or "D" to disable Internet Mansion mode,
respectively. If you press "E", the command prompt changes to "Uplink port?>."
Enter a port number you wish to configure as Uplink port. By this setting, you can
set the device to be optimum environment as a Switching Hub used in Internet
Mansion. By this setting, the specified port becomes an Uplink port, and other
ports become possible to communicate only with downlink port. Downlink ports
become impossible to communicate each other. So, it becomes possible to ensure
security between each resident. (There are some constrained conditions for use.
Please execute configuration after confirming the precautions shown in the next
page.)
O Configure a port structure in VLAN.
Press "O." The command prompt changes to "Enter VLAN ID>." Enter VLAN ID you
wish to configure with a value of 1 to 4094. Then, the screen changes to "VLAN
modification Menu" screen. For details, refer to the section (4.7.1.d).
S Configure and confirm PVID by port.
Pressing "S" opens the "VLAN Port Configuration Menu" screen. For details, refer
to the section (4.7.1.e).
G Configure a status of GVRP.
Press "G." The command prompt changes to "Enable or Disable GVRP status
(E/D)>." Enter "E" to enable or "D" to disable GVRP, respectively.
Q Return to the previous menu.
Note: When creating a new VLAN, PVID is not changed interlocked with
this new creation.
After registering VLAN on this screen, make sure to confirm the
configuration operation and configuration content on configuration
screen of Fig. 4-7-5 and Fig. 4-7-6.
When you wish to delete VLAN, you cannot delete VLAN if VLAN ID
of VLAN to be deleted is still remained as PVID. Delete VLAN after
changing PVID to other VLAN ID.
78