Panasonic M24PWR Operation Manual page 144

Available commands are listed below.
N Display the next page.
Press "N" to change the display to the next page.
P Display the previous page.
Press "P" to change the display to the previous page.
C Create Policy.
Press "C" to change the screen to the Create Policy Configuration Menu. Refer to
the section 4.7.5.k for the Create Policy Configuration.
D Delete Policy.
Press "D" to change the command prompt to "Enter a policy index>." Enter a
policy index number to be deleted.
E Enable/disable the policy status.
Press "E" to change the command prompt to "Select policy index>." Enter a policy
index number to be enabled/disabled. Then, the command prompt changes to
"Enable or Disable Policy Entry>." Press "E" to enable, and press "D" to disable.
Enabled Enable Policy.
Disabled Disable Policy.
S Display the policy information.
Press "S " to display detailed information on each policy.
U Modify the policy.
Press "U" to change the command prompt to "Enter policy index>." Enter an
index number to be modified. Then, carry out the same operation as that for
creating a policy. Remember that modification is rejected if the policy is
Enabled. If Enabled, disable the policy, and then modify it.
B Display a sequence number of policy applied to each port.
Press "B" to change the command prompt to "Enter port number>." Enter a port
number to display. Then, the command prompt changes to "Select policy index
order or policy sequence order (I/S)>." To view a policy sequence corresponding
to the policy index, press "I." To view a policy index sequence corresponding to
the policy sequence, press "S."
Q Return to the previous menu.
144