Panasonic M24PWR Operation Manual page 40

Available commands are listed below.
A Enable/disable the trap sending when the link status changes.
Press "A." The command prompt changes to "Enable or Disable SNMP
Authentication trap (E/D)>." Press "E" to enable the trap sending. Press "D" to
disable it.
P Add a port to which the trap is sent when its link status changes.
Press "P." The command prompt changes to "Enter port number>." Enter a port
number. The trap is sent for this port.
D Delete a port to which the trap is sent when its link status changes.
Press "D." The command prompt changes to "Enter port number>." Enter a port
number. The trap is not sent for this port.
E Enable/disable the trap sending when the power usage percentage exceeds the
Power Usage Threshold For Sending Trap, as set on the PoE Global Configuration
Menu.
Press "E." The command prompt changes to "Enable or Disable PoE trap (E/D)>."
Press "E" to enable the trap sending. Press "D" to disable it.
T Enable/disable the trap sending when the internal temperature exceeds the preset
temperature.
Press "T." The command prompt changes to "Enable or Disable Temperature trap
(E/D)>." Press "E" to enable the trap sending. Press "D" to disable it.
S Set a temperature threshold value to send the trap for a high device internal
temperature.
Press "S." The command prompt changes to "Enter temperature threshold>." Enter
a temperature threshold value in the range from 0 to 50 degress C to send the
trap.
F Enable/Disable the trap sending when the internal fan fails.
Press "E." The command prompt changes to "Enable or Disable Fan Failure trap
(E/D)>." Press "E" to enable the trap sending. Press "D" to disable it.
Q Return to the previous menu.
40