Table of Contents
Advertisement
Available commands are listed below.
S
Set a port to be monitored (port to which analyzer, etc. is connected).
Press "S." The command prompt changes to "Enter port number>." Enter a port
number you wish to configure.
M Configure a port to be monitored.
Press "M." The command prompt changes to "Enter port number>." Enter a port
number you wish to monitor. (Possible to configure multiple ports)
D
Configure which packet should be monitored either the transmit packet or the receive
packet.
Press "D." The command prompt changes to "Select port monitoring
direction(R/T/B)>." Enter "R" when monitoring the receive packet, or "T" when
monitoring the transmit packet, or "B" when monitoring both of the receive and
transmit packet, respectively.
C
Start or stop monitoring.
Press "C." The command prompt changes to "Enter the select(E/D)>." Enter "E" if
you wish to start (Enable) monitoring. Enter "D" if you wish to stop (Disable)
monitoring.
Q
Return to the previous menu.
Note: VLAN tag of received VLAN ID is attached to mirror packet in
Tx-direction.
Note: Management packet such as Ping or ARP transmitted from this
Switching Hub cannot be captured.
97
Advertisement
Table of Contents
