Supply Needed To Complete Job - Develop ineo 3320 User Manual

Standard network software error [54]
Try one or more of the following:
• From the printer control panel, select Continue to continue printing. For non-touch-screen printer
models, press
• Turn off the printer and then turn it back on.
• Update the network firmware in the printer or print server. For more information, contact technical
support.
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non-touch-screen printer
models, press to confirm.
Notes:
• The printer discards any data received through the USB port.
• Make sure the USB Buffer menu is not set to Disabled.

Supply needed to complete job

Do either of the following:
• Install the missing supply to complete the job.
• Cancel the current job.
Too many flash options installed [58]
1. Turn off the printer.
2. Unplug the power cord from the electrical outlet.
3. Remove the extra flash memory.
4. Connect the power cord to a properly grounded electrical outlet.
5. Turn the printer back on.
Too many trays attached [58]
1. Turn off the printer.
2. Unplug the power cord from the electrical outlet.
3. Remove the extra trays.
4. Connect the power cord to a properly grounded electrical outlet.
User's Guide
to confirm.
- 223 -