Develop ineo 3320 User Manual page 170

Use
PCL Emulation Settings
Point Size
1.00–1008.00
PCL Emulation Settings
Pitch
0.08–100.00
PCL Emulation Settings
Orientation
Portrait
Landscape
PCL Emulation Settings
Lines per Page
1–255
PCL Emulation Settings
A4 Width
198 mm
203 mm
User's Guide
To
Change the point size for scalable typographic fonts.
Notes:
• 12 is the factory default setting.
• Point size refers to the height of the characters in the font. One point
equals approximately 0.014 of an inch. This can be increased or
decreased in 0.25-point increments.
Specify the font pitch for scalable monospaced fonts.
Notes:
• 10 is the factory default setting.
• Pitch refers to the number of fixed-space characters per inch (cpi).
This can be increased or decreased in 0.01-cpi increments.
• For non-scalable monospaced fonts, the pitch appears on the display
but cannot be changed.
Specify the orientation of text and graphics on a page.
Notes:
• Portrait is the factory default setting. It prints text and graphics parallel
to the short edge of the page.
• Landscape prints text and graphics parallel to the long edge of the
page.
Specify the number of lines that print on each page.
Notes:
• 64 is the default setting.
• The printer sets the amount of space between each line based on the
Lines per Page, Paper Size, and Orientation settings. Select the paper
size and orientation before setting Lines per Page.
Set the printer to print on A4-size paper.
Notes:
• 198 mm is the factory default setting.
• The 203-mm setting sets the width of the page to allow the printing of
eighty 10-pitch characters.
- 170 -