Develop ineo 3320 User Manual page 132

Use
Eco-Mode
Off
Energy
Energy/Paper
Paper
ADF Loaded Beep
Enabled
Disabled
Run Initial setup
Yes
No
Paper Sizes
US
Metric
Scan to PC Port Range
[port range]
User's Guide
To
Minimize the use of energy, paper, or specialty media.
Notes:
• Off is the factory default setting. This resets the printer to
its factory default settings.
• Energy minimizes the power used by the printer.
Performance may be affected, but print quality is not.
• Energy/Paper minimizes the use of power and of paper
and specialty media.
• Paper minimizes the amount of paper and specialty media
needed for a print job. Performance may be affected, but
print quality is not.
Specify whether or not the ADF sounds a beep when paper is
loaded.
Note: Enabled is the factory default setting.
Run the setup wizard.
Notes:
• Yes is the factory default setting.
• After completing the setup wizard by selecting Done at the
country or region selection screen, the default becomes
No.
Specify the unit of measurement for paper sizes.
Notes:
• U.S. is the factory default setting.
• The initial setting is determined by your country or region
selection in the initial setup wizard.
Specify a valid port range for printers behind a port blocking
firewall. The valid ports are specified by two sets of numbers
separated by a semicolon.
Note: 9751:12000 is the factory default setting.
- 132 -