To Disable And Enable The Autoboot Feature; Table 7-4 Show Command Options - Sun Microsystems StorEdge A7000 Service Manual

TABLE 7-4
Command Option
show vme
show memconfig
show scsi
show slots
show serial
7.9.5

To Disable and Enable the Autoboot Feature

To determine if autoboot is enabled for a particular subsystem, type the following
from the ROM Monitor prompt in a subsystem window:
ROM >> readconfig autoboot
The subsystem window displays one of the following messages, where x is the
subsystem number 1 or 2:
subsystem dspx: autoboot: enabled
subsystem dspx: autoboot disabled
7.9.5.1 To Disable Subsystem Autobooting
Caution – Values changed by the setconfig command apply to any subsequent
reboot (caused by power on or boot/reset node commands). However, if the ROM
Monitor detects a difference between the NVRAM-stored configuration and the
actual configuration, any autoboot operation aborts and the following message
displays on the console:
WARNING: CPU / MEMORY / SCSI Configuration changed, Autoboot
aborted; Must accept new configuration to autoboot.
7-44 Sun StorEdge A7000 Service Manual • August 1999
show Command Options
Description
Display current VMEbus configuration
Display current memory configuration
Display current devices on the adapter board SCSI bus
Display current devices installed in the subsystem chassis
Display the current adapter board serial port configurations