Refitting The Ignition System And Adjusting The Fixed Spark Advance - Husqvarna CR 65 2012 Workshop Manual

1
2
altezza cilindro
accensione
3
ENGINE REASSEMBLY
CR 65 2012

Refitting the ignition system and adjusting the fixed spark advance

– Smear some Loxeal 24-18 on the three socket head screws thread and fasten
the stator (1) without tightening.
– Smear some silicone in the cable ring and fit it in the relevant opening on the
casing.
– Insert the key in the crankshaft.
– Fit the rotor on the crankshaft and mount the elastic washer with flanged
nut.
– Insert the wrench (2) in the two holes and tighten the flanged nut to 60 Nm.
– Move the piston to the L.D.C. and place the adjusting gauge on the cylinder
upper edge.
– Now the internal rotor must be turned counterclockwise until the piston upper
edge touches the adjusting gauge (see sketch).
– Now turn the stator so that the two markings 3 match.
BEFORE ADJUSTING THE FIXED SPARK ADVANCE IT IS NECES-
SARY TO CORRECTLY ADJUST DIMENSION "X".
– Smear some Loxeal 24-18 on the 3 socket head screws of the stator and
tighten them to 8 Nm.
– Check again the distance between the piston upper edge and the cylinder
upper edge using the adjusting gauge; if necessary, adjust it by turning the
stator accordingly.
H.9
Workshop Manual Ed. 09-2011