Husqvarna CR 65 2012 Workshop Manual page 140

HYDRAULICALLY CONTROLLED CLUTCH
CR 65 2012
Draining clutch fluid
Connect a plastic hose to the bleed valve and loosen the valve turning it back
by 1 or 2 turns. Remove reservoir cap and bellow diaphragm and operate the
control lever until draining all fluid.
Clutch master cylinder servicing
Drain the circuit, detach the master cylinder from the left side of the handlebar
and take it apart. Replace all seals, reassemble the master cylinder and refit it
to the handlebar. Reconnect the hose and fill fresh fluid into the reservoir. Bleed
the system as described at page P.4.
Workshop Manual Ed. 09-2011
P.4