Carburettor Adjustment; Idle Adjustment; Front Brake Fluid Level Check - Husqvarna CR 65 2012 Workshop Manual

2
1
2
Workshop Manual Ed. 09-2011
SETTINGS AND ADJUSTMENTS
CR 65 2012

Carburettor adjustment

Adjust the carburettor with warm engine and with the throttle control in closed
position. Proceed as follows:
- turn the idle speed adjuster screw (1) located on the left-hand side of the
vehicle, until setting idle RPM quite high (turn clockwise to increase the speed
1
and counter clockwise to reduce the speed).
- Turn the adjuster screw (2) clockwise to fully closed position, and then turn
it back by 3 turns.
- Gradually loosen the screw (1) until achieving suitable idle speed setting.

Idle adjustment

Adjust the carburettor with warm engine and with the throttle control in closed
position. Proceed as follows:
- Turn the idle speed adjuster screw (1) located on the left-hand side of the
vehicle, until setting idle RPM as required (turn clockwise to increase the
speed and counter clockwise to reduce it).

Front brake fluid level check

Check the front brake fluid level as follows:
- Stand the vehicle level and upright;
- Turn the handlebar so that the front brake master cylinder is in horizontal
position;
- Loosen the screws (1) and remove cover (2) together with diaphragm (3);
- Make sure the oil level is about 3 mm from the top edge, in case top-up with
oil of the type specified in the "LUBRICATION AND SUPPLIES" table.
3
D.6