Husqvarna CR 65 2012 Workshop Manual page 75

ENGINE OVERHAUL
CR 65 2012
Crankcase (crankcase half)
Warning: Carefully read this paragraph before starting the operation. Determine the reassembly sequence in order carry out a single
heating treatment on the crankcase halves to refit the bearings.
To detach or remove the bearings - if necessary even tapping with suitable tools - remove the reference bushings and place the crank-
case halves on a flat surface big enough to avoid damaging the sealing surfaces of the crankcase halves. To this end we recommend
using a wood plane.
Bearings and sealing rings should never be fitted without a suitable press, otherwise pay utmost attention and use other suitable tools.
When the casings reach 150 °C cold bearings fall in the relevant seats without any effort.
If the bearings are not well seated after cooling down, it is probable that they will turn in their seats upon following operation: it is thus
necessary to replace the crankcase.
Workshop Manual Ed. 09-2011
G.3