Shock Absorber Hydraulic Damping Adjustment - Husqvarna CR 65 2012 Workshop Manual

1
2
3
Workshop Manual Ed. 09-2011
SETTINGS AND ADJUSTMENTS
CR 65 2012
Shock absorber damping adjustment
It is possible to adjust the rebound travel of the shock absorber.
A) REBOUND - Standard setting: 2 turns (from fully closed)
To reset the standard setting, turn lower adjuster screw (1) clockwise until reach-
ing fully closed position. Then turn it back by the mentioned turns.
In order to obtain a smooth braking action, turn the adjuster screw counter
clockwise. Vice versa to obtain a harder braking action.
It is possible to adjust the compression travel of the shock absorber.
B) COMPRESSION - Standard setting: 1 turn and ½ (from fully closed)
To reset the standard setting, turn upper adjuster screw clockwise (2) until reach-
ing fully closed position. Then turn it back by the mentioned turns.
In order to obtain a smooth braking action, turn the adjuster screw counter
clockwise. Vice versa to obtain a harder braking action.
Shock absorber spring (3)
STANDARD
K=4.2 daN/mm
Spring preload (shock absorber ring nut)
Standard spring length when in its seat 217 mm ±1.5
Rebound damping (lower screw)
Standard 2 turns counterclockwise from end of travel
Compression damping (upper screw)
Standard 1 turn and ½ counterclockwise from end of trav-
el
D.18