Husqvarna CR 65 2012 Workshop Manual page 141

HYDRAULICALLY CONTROLLED CLUTCH
CR 65 2012
Filling/draining the clutch hydraulic system
2
Proceed as follows:
1
- Remove screws (1), cover (2) and rubber diaphragm (4);
- Remove the rubber cap (3) and loosen the bleed valve (5);
4
- Connect the bleed valve to a pipe, and use a syringe (6) to fill in the fluid (of
the type specified in the LUBRICANT TABLE at page A.9) until topping-up the
3 mm
master cylinder reservoir.
NEVER use brake fluid.
A
- Check that fluid level is never lower than 3 mm below the upper edge (A) of
master cylinder body. Refit any parts you have removed.
- Make sure the clutch lever reacts properly when activated: otherwise, bleed
again until removing all the air in the system.
3
3
5
5
6
Workshop Manual Ed. 09-2011
P.5