Husqvarna CR 65 2012 Workshop Manual page 139

6
Hydraulic clutch system
The hydraulic circuit is composed of a master cylinder with its reservoir located on the left side of the handlebar, and a piston installed
on the right crankcase half. The clutch is disengaged by the piston (5) that operates the pressure plate (4). Drive is transmitted from
the crankshaft to the gearbox input shaft via the gear on the clutch housing (8). The clutch housing accommodates friction plates (9)
and steel plates (10) that operate the clutch hub (6) secured to the gearbox input shaft.
1- Clutch master cylinder
2- Clutch lever
3- Master cylinder to piston hose
4- Pressure plate
5- Actuator piston
6- Clutch hub
7- Bleed fitting
8- Clutch housing with clutch ring gear
9- Steel plate
10- Friction plate
The fluid used in the hydraulic circuit will damage painted parts if spilt on them. Handle it with care when servicing
the system.
HYDRAULICALLY CONTROLLED CLUTCH
CR 65 2012
3
7
9
10
4
8
5
P.3
1
2
Workshop Manual Ed. 09-2011