Husqvarna CR 65 2012 Workshop Manual page 44

3
2
4
Workshop Manual Ed. 09-2011
SETTINGS AND ADJUSTMENTS
-
4
-
5
-
- Place the handlebar on the lower clamps paying attention to the correct rout-
ing of wires and pipes (they do not have to be twisted).
- Place the upper U-bolts (1) symmetrically and pre-tighten the screws (2) in a
crossed pattern in order to have the same front and rear distance (A) between
1
the upper and lower U-bolt.
- Once the handlebar correct inclination has been found, tighten the screws
(2) to a torque of 28 Nm (2.85 Kgm - 20.65 ft/lb).
- Keep the same distance (A) during the assembly phase.
- Refit the bumper (3) by fastening it to the handlebar with two plastic ties (4),
as shown in the picture.
3
CR 65 2012
Afterwards remove the lower ones (3) by loosening the relevant retaining
screws (4).
Use one of the two holes (5) on the steering head to move the handlebar on
or back (of nearly 17 mm - 0.67 in.).
Tighten the screws (4) to 35 Nm, 3.6 Kgm, 25.81 ft/lb.
A
D.20
A