Kick Start Pedal Shaft Removal; Gearbox Control Shaft And Selector Plate Removal - Husqvarna CR 65 2012 Workshop Manual

ENGINE DISASSEMBLY
CR 65 2012

Kick start pedal shaft removal

– Loosen the two screws (1) and remove the stop plate (2).
1
2
– Remove the kick start pedal shaft from the casing.

Gearbox control shaft and selector plate removal

3
– Use a screwdriver to push back the sliding plate (3) and at the same time
slide the gearbox control shaft out of the crankshaft.
– Remove the screw (4) and slide the selector plate out of the selector drum.
4
– Remove the circlip (5), the selector lever and spring.
5
Workshop Manual Ed. 09-2011
F.7