Refitting The Primary Drive Sprocket - Husqvarna CR 65 2012 Workshop Manual

Workshop Manual Ed. 09-2011
ENGINE REASSEMBLY
CR 65 2012

Refitting the primary drive sprocket

WARNING: Before fitting the primary drive sprocket it is necessary to degrease
the cone.
– Degrease the crankshaft thread and smear some Loxeal 100 HSP.
– Fit a new thrust washer and the hexagon nut.
– Place the retaining tool for the primary drive sprocket and tighten the hexagon
nut to 100 Nm.
– Remove the retaining tool.
Refitting the starting coupling, kick start pedal pre-load
– Fit the starting coupling (1) as shown in the kick start pedal shaft picture.
– Pre-load the kick start pedal shaft counterclockwise and engage the starting
coupling on the stopping plate (a high pre-load is not necessary).
– Oil the sliding points, fit the thrust washer (2) and the spring (3) of the starting
coupling with the small diameter faced to the coupling.
H.6