Configuring A Switch Group For Stacking - D-Link DGS-3324SR User Manual

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
The stacking ports are designated 1 and 2, and the stacking port being used will have its matching LED (on the
front panel) light a steady green when in use. Connection can be made from any stacking port to any other
stacking port. That is, stacking port 1 may connect to 1 or 2, and stacking port 2 may connect to 2 or 1

Configuring a Switch Group for Stacking

Follow the instructions below to configure the DGS-3324SR as the designated Master, and then to configure the
slave units.
To configure the DGS-3324SR to function in a stacked group as a master, do the following:
1. At the CLI login prompt, enter config box_priority current_box_id 1 priority 1
and press the Enter key. (Where the lowest priority number in a stack is always the Master, i.e. 2 would
have a higher priority than 5.)
2. Successful configuration will be verified by a Success message. It takes a few seconds for the change to
take effect. See the example below for the DGS-3324SR.
3. Be sure to save the configuration change using the CLI command save.
4. Reboot the Switch.
Figure 2-5. Star Topology Stacked Switch Group
7