Snmp Host Table - D-Link DGS-3324SR User Manual

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch

SNMP Host Table

Use the SNMP Host Table to set up SNMP trap recipients.
Open the SNMP Manager folder, and click on the SNMP Host Table link. This will open the SNMP Host
Table page, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under
the Host IP Address heading.
To add a new entry to the Switch's SNMP Group Table, click the Add button in the upper left-hand corner of
the SNMP Host Table page. This will open the SNMP Host Table Configuration page, as shown below.
The following parameters can set:
Parameter
IP Address
SNMP Version
Figure 5- 10. SNMP Host Table
Figure 5- 11. SNMP Host Table Configuration
Description
Type the IP address of the remote management station that will serve as
the SNMP host for the switch.
V1 – To specifies that SNMP version 1 will be used.
V2 – To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv – To specify that the SNMP version 3 will be used,
with a NoAuth-NoPriv security level.
V3-NoAuth-NoPriv – To specify that the SNMP version 3 will be used,
with a NoAuth-NoPriv security level.
V3-Auth-NoPriv – To specify that the SNMP version 3 will be used, with a
Auth-NoPriv security level.
V3-Auth-Priv – To specify that the SNMP version 3 will be used, with a
Auth-Priv security level.
under the Delete heading.
137