D-Link DGS-3324SR User Manual page 126

High-density layer 3 stackable gigabit ethernet switch
Hide thumbs Also See for DGS-3324SR:
Table of Contents

Advertisement

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
For stub area, Type 3 summary link advertisements can also be used to describe a default route on a per-area
basis. Default summary routes are used in stub area instead of flooding a complete set of external routes. When
describing a default summary route, the advertisement's Link State ID is always set to the Default Destination −
0.0.0.0, and the Network Mask is set to 0.0.0.0.
Separate costs may be advertised for each IP Type of Service. Note that the cost for TOS 0 must be included,
and is always listed first. If the T-bit is reset in the advertisement's Option field, only a route for TOS 0 is
described by the advertisement. Otherwise, routes for the other TOS values are also described. If a cost for a
certain TOS is not included, its cost defaults to that specified for TOS 0.
Field
Network Mask
TOS
Metric
Autonomous Systems External Link Advertisements
Autonomous Systems (AS) link advertisements are Type 5 link state advertisements. These advertisements are
originated by AS boundary routers. A separate advertisement is made for each destination known to the router,
that is external to the AS.
AS external link advertisements usually describe a particular external destination. For these advertisements the
Link State ID field specifies an IP network number. AS external link advertisements are also used to describe a
default route. Default routes are used when no specific route exists to the destination. When describing a default
route, the Link Stat ID is always set the Default Destination address (0.0.0.0) and the Network Mask is set to
0.0.0.0.
The format of the AS External Link Advertisement is shown below:
Summary Link Advertisements
Link-State Age
Link-State ID
Advertising Router
Link-State Sequence Number
Link-State Checksum
Network Mask
TOS
Description
For Type 3 link state advertisements, this indicates the destination
network's IP address mask. For example, when advertising the
location of a class A network the value 0xff000000
The Type of Service that the following cost is relevant to.
The cost of this route. Expressed in the same units as the
interface costs in the router links advertisements.
Table 4- 16. Summary Link Advertisement
111
2
Options
Length
Metric

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents