D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
DNSR Cache Status
<Disabled>
DNS Static Table
Status <Disabled>
Click Apply to implement the new settings.
DNS Relay Static Table
To view the DNS Relay Static Table, open the DNS Relay folder in the Configuration folder to Layer 3 IP
Networking, and click the DNS Relay Static Table link, which will open the following window.
To add an entry into the DNS Relay Static Table, simply enter a Domain Name with its corresponding IP
address and click Add. A successful entry will be presented in the table below, as shown in the example above.
To erase an entry from the table, click the
IP Multicasting
The functions supporting IP multicasting are added under the IP Multicast Routing Protocol folder, from the
Layer 3 IP Networking folder.
IGMP Snooping, DVMRP, and PIM-DM can be enabled or disabled on the Switch without changing the
individual protocol's configuration.
IGMP Interface Configuration
The Internet Group Multicasting Protocol (IGMP) can be configured on the Switch on a per-IP interface basis.
To view the IGMP Interface Table, open the IP Multicast Routing Protocol folder under Configuration and
click IGMP Interface Settings. Each IP interface configured on the Switch is displayed in the below IGMP
Interface Table dialog box. To configure IGMP for a particular interface, click the corresponding hyperlink for
that IP interface. This will open another IGMP Interface Configuration window:
This can be toggled between Disabled and Enabled. This determines if a
DNS cache will be enabled on the switch.
This field can be toggled using the pull-down menu between Disabled and
Enabled. This determines if the static DNS table will be used or not.
Figure 4- 83. DNS Relay Static Table
corresponding to the entry you wish to delete.
123