Static/Default Route - D-Link DGS-3324SR User Manual

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
Type
Metric
Click Apply to enter the new settings. To delete an entry, click the corresponding
NOTE: The source protocol (Src Protocol) entry and the destination
protocol (Dest Protocol) entry cannot be the same.

Static/Default Route

Entries into the Switch's forwarding table can be made using both MAC addresses and IP addresses. Static IP
forwarding is accomplished by the entry of an IP address into the Switch's Static IP Routing Table.
This window shows the following values:
Parameter
IP Address
Subnet Mask
Gateway
Hops
Protocol
Backup State
Delete
Allows for the selection of one of six methods of calculating the metric value.
The user may choose between All, Internal, External, ExtType1, ExtType2,
Inter-E1, Inter-E2. See the table above for available metric value types for
each source protocol.
Allows the entry of an OSPF interface cost. This is analogous to a Hop
Count in the RIP routing protocol.
Figure 4- 62. Static/Default Routes Settings window
Description
The IP address of the Static/Default Route.
The corresponding Subnet Mask of the IP address entered into the table.
The corresponding Gateway of the IP address entered into the table.
Represents the metric value of the IP interface entered into the table. This
field may read a number between 1-65535 for an OSPF setting, and 1-16 for
a RIP setting.
Represents the protocol used for the Routing Table entry of the IP interface.
This field may read OSPF, RIP, Static or Local.
Represents the Backup state that this IP interface is configured for. This
field may read Primary or Backup.
Click the if you would like to delete this entry from the Static/Default
Route Settings table.
92
under the Delete heading.