Setting Up Ip Interfaces - D-Link DGS-3324SR User Manual

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
ARP Aging Time

Setting Up IP Interfaces

Each VLAN must be configured prior to setting up the VLAN's corresponding IP interface.
An example is presented below:
VLAN Name
System (default)
Engineer
Marketing
Finance
Sales
Backbone
In this case, 6 IP interfaces are required, so a CIDR notation of 10.32.0.0/11 (or a 11-bit) addressing scheme will
work. This addressing scheme will give a subnet mask of 11111111.11100000.00000000.00000000 (binary) or
255.224.0.0 (decimal).
Using a 10.xxx.xxx.xxx IP address notation, the above example would give 6 network addresses and 6 subnets.
Any IP address from the allowed range of IP addresses for each subnet can be chosen as an IP address for an IP
interface on the switch.
For this example, we have chosen the next IP address above the network address for the IP interface's IP
Address:
VLAN Name
System (default)
Engineer
Marketing
Finance
Sales
Backbone
The 6 IP interfaces, each with an IP address (listed in the table above), and a subnet mask of 255.224.0.0 can be
entered into the Setup IP Interface window.
To setup IP Interfaces on the switch:
The user may globally set the maximum amount of time, in minutes, that an
Address Resolution Protocol (ARP) entry can remain in the Switch's ARP
table, without being accessed, before it is dropped from the table. The value
may be set in the range of 0-65535 minutes with a default setting of 20
minutes.
VID
1
2
3
4
5
6
Table 4- 4. VLAN Example – Assigned Ports
VID
1
2
3
4
5
6
Table 4- 5. VLAN Example – Assigned IP Interfaces
Switch Ports
5, 6, 7, 8, 21, 22, 23, 24
9, 10, 11, 12
13, 14, 15, 16
17, 18, 19, 20
1, 2, 3, 4
25, 26
Network Number
10.32.0.0
10.64.0.0
10.96.0.0
10.128.0.0
10.160.0.0
10.192.0.0
88
IP Address
10.32.0.1
10.64.0.1
10.96.0.1
10.128.0.1
10.160.0.1
10.192.0.1