Ospf Host Route Settings - D-Link DGS-3324SR User Manual

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
Specify the OSPF Aggregation settings and click the Apply button to add or change the settings. The new settings
will appear listed in the OSPF Area Aggregation Settings table. To view the table, click the
Aggregation Entries link which will return to the previous window.
Configure the following settings for OSPF Area Aggregation:
Parameter
Area ID
Network Number
Network Mask
LSDB Type
Advertisement

OSPF Host Route Settings

OSPF host routes work in a way analogous to RIP, only this is used to share OSPF information with other OSPF
routers. This is used to work around problems that might prevent OSPF information sharing between routers.
To configure OSPF host routes, click the OSPF Host Route Settings link. To add a new OSPF Route, click the
Add button. Configure the setting in the menu that appears. The Add and Modify menus for OSPF host route
setting are nearly identical. The difference being that if you are changing an existing configuration you will be
unable to change the Host Address. To change an existing configuration, click on the hyperlinked Host Address
in the list for the configuration you want to change and proceed to change the metric or area ID. To eliminate an
existing configuration, click the
Use the menu below to set up OSPF host routes.
Description
Allows the entry the OSPF Area ID for which the routing information will be
aggregated. This Area ID must be previously defined on the switch.
Sometimes called the Network Address. The 32-bit number in the form of
an IP address that uniquely identifies the network that corresponds to the
OSPF Area above.
Enter the subnet Mask of the Network Number entered above. Each
address range is defined as a pair (address, mask) and both must be
correctly entered to properly configure the OSPF Aggregation.
This field denotes only one LSDB Type, Summary, on the Switch. Future
releases of this Switch will have the capability to choose alternate LSDB
types.
Select Enabled or Disabled to determine whether the selected OSPF Area
will advertise it's summary LSDB (Network-Number and Network-Mask).
in the Delete column for the configuration to be removed.
Figure 4- 78. OSPF Host Route Settings table
119
Show All OSPF