Configuring The Switch - D-Link des-1316 Quick Installation Manual

Configuring the Switch

The 8-Port 10/100Mbps Ethernet Web Smart Switch with 8-Port PoE has a Web GUI
interface for smart switch configuration. The Switch can be configured through the Web
Browser. A network administrator can manage, control, and monitor the Switch from the
local LAN. This section indicates how to configure the Switch to enable its smart
functions including:
Port Settings (Speed/Duplex and Flow Control)
VLAN Settings (802.1Q VLAN)
Trunking
Port Mirroring
PoE Settings
System Settings
Device status and Statistics
Login
Before you configure this device, note that when the Web Smart Switch is configured
through an Ethernet connection, the manager PC must be set on same the IP network.
For example, when the default IP address of the Web Smart Switch is 192.168.0.1, then
the manager PC should be set at 192.168.0.x (where x is a number between 2 and 254),
and the default subnet mask is 255.255.255.0.
Open Internet Explorer 5.0 or above Web browser.
Enter the IP address http://192.168.0.1 (the factory-default IP address setting) into the
address location. (Figure 2.)
Figure 2.
9