Operating Problems - Wexiodisk WD-6C Installation And User Manual

Operating instructions

4.3.5 Operating problems

Check:
•
•
•
•
Troubleshooting
The following errors can be dealt with by the operator. If the problem persists,
contact authorised service personnel.
PROBLEM
The machine will not start.
The machine does not fill with
water.
The machine fills slowly.
The machine does not stop
filling.
The machine does not start
washing.
Noise from the washing pump.
The machine stops in the middle
of the washing cycle and starts
taking in water.
WD-6C
Has the appliance been used according to the instructions?
Are all the removable parts in their correct place?
Is the main switch in the ON position?
Are the fuses in the electrical cabinet still intact? Ask service personnel to
check the fuses.
CAUSE
Power switch off.
The incoming water stopcock is
closed.
The circuit breaker has tripped.
The door/hood is open.
The level pipe is not in place.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
The rinse pipe nozzles are blocked.
The rinse pipe nozzles are blocked.
The level pipe is not in place.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
The door/hood is open.
Dishware is blocking the magnet in
the door.
Low water level. Foam in the tank.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
37
Rev. 7.0 (202202)
ACTION
Switch on the power switch.
Open the tap.
Reset the circuit breaker.
Close the door/hood.
Fit the level pipe.
Adjust the level pipe. Check that the
rubber sleeve has not been
damaged. Change the rubber sleeve
if it is damaged.
Clean the wash nozzles.
Clean the wash nozzles.
Fit the level pipe.
Adjust the level pipe. Check that the
rubber sleeve has not been
damaged. Change the rubber sleeve
if it is damaged.
Close the door/hood.
Remove the dishes in question.
Check the level. Change the water.
Adjust the level pipe. Check that the
rubber sleeve has not been
damaged. Change the rubber sleeve
if it is damaged.