Solo Isolate - Solid State Logic SL 9000 J Series Operator's Manual

SL 9000 J Console Operator's Manual
SOLO
10
CUT
20
30
LF
40
MIX
60
ISO
C
ST
L R
M P
REC
SOLO CUT
CUT – When the Large Fader is used in the Channel signal path the CUT button
normally cuts the channel in two places – at the input and immediately post the fader.
This means that Pre-fade aux sends will be muted by the Cut switch or by a
Destructive Solo
STATUS – This switch beside the Large Fader (see opposite) is related to the
automation system, as are the trim, abs and alt LEDs. See the J Series Computer
Operator's Manual for more details.
3-18
If SOLO IN FRONT is selected on the SL952, the SOLO
buttons provide a mix of the AFL signal and the main Mix
signal on the main monitors. A rotary control adjusts the
balance between AFL and MIX.

Solo Isolate

If the module's ISO switch is selected, then the Large fader
signal path will not be cut by another channel being Soloed.
The ISO switch can also solo isolate the Small Fader. To do this
hold down the Small Fader SOLO switch while selecting ISO.
The solo isolate function will now always apply to the Small
Fader. This link can be cleared by holding down the Large
Fader SOLO switch and selecting ISO (or by turning the
console off and on again).
22.12.94