Solid State Logic SL 9000 J Series Operator's Manual page 304

The Mix System
Set Multiple – Allows you to set up protection modes on different objects across the
console. This applies to both channels and groups. Stab on Set Multiple and all the
non-latching object LEDs/key caps will be lit. Stab on the Channels box and the
Channel Selector pop-up will appear. Make your selections, as described in Section 1
of this manual, and then choose which objects you would like to protect – FX1-6,
Insert, EQ, Cue, SF Cut and LF Cut, by selecting the appropriate box (blue), on the
right of the pop-up. To protect Group Cuts and Solos, stab on the Groups box and the
Groups Selector pop-up will appear. Make your selection and then select either Grp
Cut or Grp Solo.
Now toggle to the protection mode you require (in the box at the top centre of the pop-
up), and finally hit Do Multiple (this box only appears when Set Multiple is selected)
to apply the protection.
Set Random – Use this for totally random selections. Stab on Set Random, toggle to
the required protection mode, and then simply press the switches you wish to place in
that mode. The associated LED/lamp will light to confirm the selection. Repeat the
process if you want to have additional objects in the alternative protected mode.
Set Single – User this for single switches. Select Set Single and then press the switch
that you wish to protect. Its LED/lamp will light and the name and number of that
switch will appear in the box directly to the right of the Set Single box. If you continue
to press the switch, it will toggle through the different protection modes.
If the switch is out of reach, stab on the switch identity box and a pop-up will appear
(see opposite). To change the current channel number stab on the Channel 1 box and
use the numerical pop-up. Use the same procedure to change to a different Group.
Now, by stabbing on the list of objects to the right of the pop-up, select (red) the switch
you wish to assign to a protection mode. Note that these selections intercancel. Having
made your choice, hit OK. Finally, select the protection mode as above, by stabbing in
the box in the top centre of the Switch Protection pop-up.
Clear the Switch Protection pop-up by stabbing outside it or by deselecting the
SWITCH PROT button.
5-61
20.8.96