Fader Status Copy - Solid State Logic SL 9000 J Series Operator's Manual

The Mix System
Note that the previous statement will also apply to Merge Trim (see Page 5-51), as
long as Always/New Pass is selected, and you roll back before hitting MERGE TRIM.
In this case, the pass prefix will be M. If you hit MERGE TRIM before rolling back, the
system will first create another mix pass, and then merge the Trim data with that pass,
creating a pass prefixed with M. Note that Merge Trim will not work while the system
is in Play.
We recommend that Always/New Pass is used as the default setting for this option, in
order that you never accidentally lose any data or the opportunity to revert to a
previous pass, by combining a new modification with that existing data (as with
Play/New Pass). There may be occasions, however, particularly with Copy/Swap (see
Page 5-91), when you wish to repeat a procedure several times. In this case it would be
better to select Play/New Pass in order to prevent the creation of a new mix pass after
each operation, which may cause the previous pass to be forced from the Mix Pass list
as it overflows. Remember that Keep (see Page 5-13) can be used to prevent this
happening or, for total insurance, save the mix pass to disk before using Edit Mix,
Offline Trim, Join to Mix etc.
The settings of the following items in the Fader Status pop-up may be saved to a
Project File under Desk Setup: Status Lock On/Off, Insert Mixing On/Off, Use
Abs/Trim, Renull On/Off, Snap On/Off, Autoglide On/Off and Time, Autofade
On/Off and Time, Immediate Pickup On/Off, Autotakeover On/Off, Preview On/Off
and Always/New Pass – Play/New Pass.

Fader Status Copy

This useful feature enables the current selection of fader statuses to be stored and
recalled at a later stage.
Select fader statuses as required, then press and hold the front panel FADER STATUS
COPY button until it flashes. Now at any point, fader statuses and controls can be
reset to the stored settings by a quick press of the FADER STATUS COPY button. The
current status store can be cleared by turning AUTO off and on again.
Faders stored with a Preview status will be reset to their active status unless Preview
On (see Page 5-49) is currently selected.
5-53
23.8.96