Connecting The Network Cable; Figure 2-7 Main Alarm Adapter Input (Detail); Table 2-6 Alarm Input Pin Definitions - Honeywell HDZ20HD User Manual

1 2 3 4 5 6 7 8 9 10 11 12

Connecting the Network Cable

Connect a Category 5 or higher Ethernet cable to the RJ45 connector on the back plate of the
camera (see
(100 m). After you have connected the Ethernet cable, check the status of the LED indicators on
the RJ45 connector. If the LEDs are not lit, re-check the connection.
•
•
Figure 2-7 Main Alarm Adapter Input (Detail)
Table 2-6 Alarm Input Pin Definitions
Pin Definition
1 Alarm Out NO 1
2 Alarm Out NC 1
3 Alarm Out COM 1
4 GND
5 Alarm Out NO 2
6 Alarm Out NC 2
Figure 2-5 on page
The green LED indicates a network connection.
The orange LED indicates network activity.
Note You may need to use a crossover cable if you are connecting the
camera directly to a PC.
Inputs (x4) 5V, 4700 Ohms, pull up
Outputs (x2) Relay output, 120 V AC/30 V DC, 3 A MAX
Note Use alarm outputs for SELV circuits only.
Pin
7
8
9
10
11
12
29). The Ethernet cable should not be longer than 328 feet
Installing the Camera | 31
Definition
Alarm Out COM 2
GND
Alarm In 4
Alarm In 3
Alarm In 2
Alarm In 1
800-11873V4 - A - 07/2014