Connecting The Cables; Figure 2-5 Camera Back Plate Layout; Table 2-3 Camera Back Plate Connectors, Switches, And Buttons - Honeywell HDZ20HD User Manual

Connecting the Cables

Before connecting the cables, take a minute to familiarize yourself with the camera's back plate
connectors, switches, and buttons, as shown in
Indoor IP PTZ Dome Camera
B
F
G
A RJ45 connector (see
B Alarm Input/Output (see
C Power (see
D MicroSDHC Memory Card Slot (install a microSDHC card from 8 to 32 GB, as needed). See
MicroSDHC Card Details on page 30
E Factory Reset Button
F Audio Input/Output (see
G Eyelet to secure camera to building with lanyard during camera setup
a
Alarm, Power and Audio connections are made with removable connectors.
b
Press the factory reset button to restore all camera settings to the factory default settings.
Note Optional: the installer can use the lubricant on the rubber ring on the top of the
outdoor PTZ to make it easier to re-attach to the housing and seal the PTZ dome
cover and housing without water coming in. Be careful to not get any lubricant on
the dome as it may interfere with viewing PTZ images.
Figure 2-5 Camera Back Plate Layout
E
C
A
D
Table 2-3 Camera Back Plate Connectors, Switches, and Buttons
Connecting the Network Cable on page 31
Connecting Alarm Inputs/Outputs on page 30
Connecting Power on page 32
b
Connecting Audio on page 30
Figure 2-5 and Table 2-3
Outdoor IP PTZ Dome Camera
F
D
G
for more information)
for more information.
for more information)
Installing the Camera | 29
below.
B
E
C
A
for more information)
for more information)
a
a
800-11873V4 - A - 07/2014
a