92 | HDZ Series IP PTZ User Manual
Setting the Alarm Actions
You can specify what actions you want the camera to perform when the selected alarm is
triggered. You can select more than one action from the following options.
Enabling the Alarm Relay Output
Under Triggered action (see
Enable alarm output 2 check boxes.
Sending a Message to the Configured FTP/Email Server
Under Triggered action, select one or both of the following:
Uploading Images to a Configured FTP/Email Server
The Send message by FTP check box to send the message to the FTP server (see
Configuring FTP Servers on page 88
The Send message by E-Mail check box to send the message to the mail server (see
Configuring Email SMTP Servers on page 87
Under Triggered action, select the Upload image by FTP/E-Mail check box. The
uploading images options will appear below the check box (see
Upload Image by FTP/E-Mail Options
In the FTP/E-Mail address drop-down list, select either FTP1/E-Mail1 or FTP2/E-Mail2
Configuring FTP Servers, page
for information on setting up an Email and/or FTP address).
In the Pre-trigger buffer drop-down list, select the number of pre-trigger frames/images (1
to 20) to send to the server. This option sets the amount of images from before an alarm is
triggered that will be uploaded by FTP/Email. The default setting is 5.
In the Post-trigger buffer drop-down list, select the number of post-trigger frames/images
(1 to 20) to send to the server. The default setting is 5.
To continue to upload images to the server for a specified time, or until the alarm ends,
select the Continue image upload check box, and choose one of the following options:
Upload for [number] sec and enter a value from 1 to 9999 seconds.
Upload during trigger active.
6-5), select one or both of the Enable alarm output 1 and
for information on setting up an FTP server).
for information on setting up an email server).
Configuring Email SMTP Servers on page