Honeywell HDZ20HD User Manual page 156

156 | HDZ Series IP PTZ User Manual
Step 3: Attach the camera to bracket frame
1.
2.
Step 4: Install the camera and bracket assembly
1.
2.
3.
www.honeywell.com/security
Place the camera against the base of the bracket frame and twist it clockwise until it locks
in place.
Tighten the pre-installed Torx screw on the camera housing to secure the camera to the
bracket frame.
Pull the loose end of the safety cable through the
opening in the ceiling and attach it to one of the
eyelets on the bracket frame.
Pull the camera cable(s) through the opening in the
ceiling and connect the cable(s) to the camera.
Insert the camera and bracket assembly into the
opening in the ceiling and attach the camera and
bracket assembly to the ceiling support ring using
the two supplied thumb screws. Use a Phillips
driver to tighten the screws.