Removing A Drum Roller - KitchenAid Pro Line KHEV01RSS Technical Education

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Remove the belt and drum from the dryer
(see pages 4-19 through 4-21 for the pro-
cedure).
NOTE: The front and rear rollers are replaced
in the same manner. However, the front roller
brackets are held in place with studs, while
the rear panel roller brackets are held in place
with bolts. The rear rollers are shown in this
procedure.
4. Mark the position of the roller bracket bolts
on the rear support panel prior to loosening
them. The hardware must be reinstalled in
the same position to maintain the proper
roller adjustment.
5. Remove the three 7/16˝ bolts and washers
and remove the bracket and roller (see the
top right photo). NOTE: To remove the left
roller (facing the rear of the support panel),
you will have to remove the air duct to ac-
cess two of the bolts.

REMOVING A DRUM ROLLER

6. Remove the 1/2˝ nut and washer from
the roller and remove the roller from the
bracket. NOTE: Mount the replacement
roller to the bracket with the 1/2˝ nut, and
tighten it securely before you mount the
bracket to the panel.
Roller
Bracket
7. Locate the roller bracket bolt locations that
you marked in step 4, then mount the roller
with the bolts over the marks, and tighten
the bolts securely.
4-25
Air Duct
Left & Right
Roller Bracket
Hardware
Pivot Point
Roller Nut
& Washer