KitchenAid Pro Line KHEV01RSS Technical Education page 61

b) Lift the bottom of the rear support panel
off the back of the drum just far enough
to slide the belt down behind the drum
and remove it.
19. To remove the drum:
a) Lift the rear support panel off the back
of the dryer, and position it so it is clear
of the drum.
b) Pull the belt off the pulley.
Position Rear Support
Panel Out Of The Way
c) Be careful not to catch the front of the
drum on the end of the drum sensor
inside the front panel, and lift the drum
straight up and out of the dryer cabinet.
REASSEMBLY NOTE: The replacement belt
will have to be stretched when mounting it around
the drum and the motor pulley. The following
procedure will assist in helping to stretch the
belt, using the rear support panel and drum as
leverage.
To reinstall a new belt on the unit:
1. If not already done, install the drum in the
dryer.
2. Loop the new belt over the drum and onto
the drive motor pulley.
3. Place the rear support panel on the back of
the unit, and align the two mounting holes
for the Allen trunnion screws. Install the
screws and secure the support panel to
the drum.
4. Close the cover plate and secure it with its
mounting screws.
5. Pull either side of the rear support panel
up so that the top cabinet side panel tab
fits into the slot of the support panel, as
shown below. Press the side panel against
the support panel to hold it in place and
install a T-20 screw at that mounting hole
location.
6. Pull the other side of the rear support panel
up so that the top cabinet side panel tab
fits into the slot of the support panel. Press
the side panel against the support panel
to hold it in place and install a T-20 screw
at that mounting hole location.
7. Install the remaining four T-20 screws in
the rear support panel and tighten them
securely.
8. Raise the dryer to its upright position and
reinstall the rear panel on the unit.
4-21
Position Side Panel Tab
In Support Panel Slot